cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
566
Views
0
Helpful
4
Replies

OIR fault

bhowieson
Level 1
Level 1

The following message is spuriously appearing on the command line of a Cisco3640 we are using. It is populated with 1 2FE card and 3 NM4T cards. The router has hung but i can find no reason for this - any help appreciated.

%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat F00

4 Replies 4

Hello,

the reason might be a mis-seated network module; since you have several of them, you might want to try to reseat them. There could also be a power supply problem and could indicate a power supply voltage drop.

Check out this document for more info:

http://www.cisco.com/en/US/partner/products/hw/routers/ps274/products_tech_note09186a0080109510.shtml

Regards,

Georg

Thanks for that Georg, however i am unable to get the link to work. How can i check the power supply.

Cheers

Barry

Hello,

you can see some details on the power supply by issuing the show environment command. If you post your email address I send you the link as a saved file.

Regards,

Georg

Thanks again, email is bhowieson@scotamb.co.uk

Review Cisco Networking for a $25 gift card