PA-MC-T3 & 7200

[nbhungalia]

I'm trying to install PA-MC-T3 on to 7200 and I've tried couple different IOS (12.1.15, 12.0.7T2, 12.1.1aT1, 12.0.3T3) and none of these IOS' seem to recognize this card. Router Configuration is as follow:

7204, NPE150, FE I/O Card with MII, PA-T3 (working - trying to replace this with PA-MC-T3).

I would like to know if anyone is aware of any known issues or if anyone has any suggestions.

Thank you in advance -

[rsissons]

I believe the PA-MC-T3 is only supported in the 7200 VXR router.

[nbhungalia]

Thanks for your reply! I tried to look for a white paper on CCO to verify this but was unable to find anything. However, I did find the following information which suggets that the PA-MC-T3 should work with 7204. Any thoughts??

Objectives

This document describes how to install and configure the PA-MC-T3 Multi-channel T3 port adapter (PA-MC-T3[=]), hereafter referred to as the PA-MC-T3 which is used in the following platforms:

Catalyst 5000 family switches with the Route Switch Module (RSM)/second-generation Versatile Interface Processor (VIP2)

Catalyst 6000 family FlexWAN module in the Catalyst 6000 family switches

Cisco 7200 series routers, consisting of the two-slot Cisco 7202, four-slot Cisco 7204 and Cisco 7204VXR, and the six-slot Cisco 7206 and the Cisco 7206VXR

Cisco uBR7200 series universal broadband routers, consisting of the six-slot Cisco uBR7246 and the three-slot Cisco uBR7223

Cisco 7401ASR router

Second-generation Versatile Interface Processor (VIP2) in Cisco 7500 series and Cisco 7000 series routers with the 7000 Series Route Switch Processor (RSP7000) and 7000 Series Chassis Interface (RSP7000CI)

Fourth-generation Versatile Interface Processor (VIP4) in Cisco 7000 Series routers with the 7000 Series Route Switch Processor (RSP7000) and 7000 Series Chassis Interface (RSP7000CI) and in Cisco 7500 Series routers

http://www.cisco.com/univercd/cc/td/doc/product/core/cis7505/portadpt/multi_ch/mc_t3/5265pref.htm