Hi,
I have a router with 2 interfaces and for each interface a tunnel with ipsec protection for connection to a router.
My problem is that tunnel destination for both tunnels is an address direct connected to my router (ethernet interface conected to a metropolitan lan) and the tunnel which I want to go within serial interface raise just in case of shutting ethernet interface. I try to do a PBR with ip local policy and route-map for send packets with source address of serial to serial interface (or to next-hop wich is peer to serial interface) but isn't work (I'm not shure that tunnel packets are local generate and need to work with an ip local policy).I don't have rights on the other router to configure an loopback interface on wich to finish my tunnel.
Any ideea?
