02-04-2005 04:57 AM - edited 03-02-2019 09:29 PM
I need to know one CLI to indicate the power used in each WS-CAC-2500W.
The command sh power only diplay the power used in both WS-CAC-2500W.
Regards,
Martín
02-10-2005 07:14 AM
The modules have different power requirements, and some configurations require more power than a single power supply can provide. The power management feature allows you to power all installed modules with two power supplies. However, redundancy is not supported in this configuration because the total power drawn from both power supplies is at no time greater than the capability of one supply. Redundant and nonredundant power configurations are described in the following sections.
For more information, could you please refer the following link:
02-10-2005 03:00 PM
Hi,
But I need to know why these two supply is in active?
RO_MSFC_HIPOLITO#sh power
system power redundancy mode = redundant
system power total = 2331.00 Watts (55.50 Amps @ 42V)
system power used = 1038.66 Watts (24.73 Amps @ 42V)
system power available = 1292.34 Watts (30.77 Amps @ 42V)
Power-Capacity PS-Fan Output Oper
PS Type Watts A @42V Status Status State
---- ------------------ ------- ------ ------ ------ -----
1 WS-CAC-2500W 2331.00 55.50 OK OK on
2 WS-CAC-2500W 2331.00 55.50 OK OK on
Pwr-Requested Pwr-Allocated Admin Oper
Slot Card-Type Watts A @42V Watts A @42V State State
---- ------------------ ------- ------ ------- ------ ----- -----
1 WS-X6K-SUP2-2GE 142.38 3.39 142.38 3.39 on on
2 - - 142.38 3.39 - -
3 WS-X6816-GBIC 249.48 5.94 249.48 5.94 on on
4 WS-X6816-GBIC 249.48 5.94 249.48 5.94 on on
5 WS-X6500-SFM2 129.78 3.09 129.78 3.09 on on
7 WS-X6548-GE-TX 125.16 2.98 125.16 2.98 on on
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide