--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note --
im trying to implement RAS server so a remote unix server can dial in using SLIP. The user dials in OK but having issues passing L3 traffic. Sh ip route shows route for the user. Im copying the config . Any suggestions on the config or troubleshooting would be great
Current configuration : 1875 bytes
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname xxx
!
boot system flash c3660-is-mz.122-16a.bin
logging queue-limit 100
enable -- moderator edit-- password **********
!
username test password 0 test
ip subnet-zero
!
!
no ip domain-lookup
!
isdn switch-type primary-net5
isdn voice-call-failure 0
modemcap entry mica_rog:MSC=&F&D2S0=0S34=18000S40=10S10=50debugthismodemS71=4s53=0
call rsvp-sync
!
!
!
!
!
fax interface-type fax-mail
mta receive maximum-recipients 0
!
controller E1 1/0
pri-group timeslots 1-31
!
controller E1 2/0
pri-group timeslots 1-31
!
!
!
interface Loopback1
ip address 10.10.10.1 255.255.255.0
!
interface FastEthernet0/0
ip address 10.10.11.1 255.255.255.0
speed 100
full-duplex
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial1/0:15
ip unnumbered Loopback1
encapsulation ppp
dialer-group 1
isdn switch-type primary-net5
isdn incoming-voice modem
no fair-queue
!
interface Serial2/0:15
no ip address
isdn switch-type primary-net5
isdn incoming-voice modem
no fair-queue
!
interface Group-Async1
ip unnumbered Loopback1
encapsulation slip
dialer in-band
dialer idle-timeout 1200
dialer-group 1
async default routing
async dynamic address
async mode interactive
no peer default ip address
group-range 97 158
!
ip classless
ip http server
!
access-list 101 permit ip any any
dialer-list 1 protocol ip list 101
!
dial-peer cor custom
!
!
!
!
line con 0
-- moderator edit-- password **********
login
line 97 126
flush-at-activation
login local
modem InOut
modem autoconfigure type mica_rog
transport input all
autoselect during-login
line 129 158
flush-at-activation
login local
modem InOut
transport input all
autoselect during-login
line aux 0
-- moderator edit-- password **********
login
line vty 0 4
-- moderator edit-- password **********
login
!
end
