02-22-2010 12:48 PM - edited 03-03-2019 05:52 AM
I recently upgraded the code on one of our
6500 switches. Ever since the upgrade, I can log into the switch with no problem. However, when I go to enable mode, it prompts me once again for the username before the enable password. Not sure if anyone ever saw this. It would be nice to only have to enter my username once instead of again when I go to enable mode. Thx!
Switch>en
User Access Verification
Username:
02-23-2010 03:46 AM
I recently upgraded the code on one of our
6500 switches. Ever since the upgrade, I can log into the switch with no problem. However, when I go to enable mode, it prompts me once again for the username before the enable password. Not sure if anyone ever saw this. It would be nice to only have to enter my username once instead of again when I go to enable mode. Thx!
Switch>en
User Access Verification
Username:
Hi,
Can you share the configuration related to aaa configuration in your switch.
Ganesh.H
02-23-2010 06:56 AM
Hello,
Here are the statements from my switch:
aaa new-model
aaa authentication login default group tacacs+ local
aaa authentication login admin line
aaa authentication enable default group tacacs+ enable
aaa authentication ppp default local
aaa authorization exec default group tacacs+ local
aaa authorization network default local
aaa accounting network default start-stop group tacacs+
aaa accounting connection default start-stop group tacacs+
Thanks,
Dan P.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: