04-03-2003 07:01 PM - edited 03-02-2019 06:23 AM
Hi All,
I saw "priority-queue out "command in 3550, does anybody knows its meaning and how to use it?
Waimen
Solved! Go to Solution.
04-03-2003 07:53 PM
Hi Waimen,
Each ethernet port on the 3550 has four egress queues, one of which can be the egress expedite queue. All four queues participate in the WRR unless the expedite queue is enabled, in which case, the fourth queue is ignored and not used in the ratio calculation. The expedite queue is a strict-priority queue, and it is serviced until empty before the other queues are serviced. You enable the expedite queue by using the priority-queue out interface configuration command.
Hope this helps!
You may check this link too:
04-03-2003 07:53 PM
Hi Waimen,
Each ethernet port on the 3550 has four egress queues, one of which can be the egress expedite queue. All four queues participate in the WRR unless the expedite queue is enabled, in which case, the fourth queue is ignored and not used in the ratio calculation. The expedite queue is a strict-priority queue, and it is serviced until empty before the other queues are serviced. You enable the expedite queue by using the priority-queue out interface configuration command.
Hope this helps!
You may check this link too:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide