cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
283
Views
0
Helpful
1
Replies

reboot after short power outage

Hi,

We have a setup with 2 power supplies "NET 1" = main power and "NET 2" = backup power where NET 1 is the main power supply feeding the cisco switches. We have a device from schneider electric called transferpact we would like to install  to switch to NET 2 in case of power loss on NET 1. Switching between the 2 power sources will result in a power loss or power down time for less than 500 ms to the switches. Will the switches keep running as if nothing happened or what is the minimum switchover time the switches need to continue working as if nothing happened on the power to the switches ?

This device would eliminate the use of separate UPS as we are 100% certain of power being available on NET 2 (through UPS and diesel generator from the power grid) 

Thank you for any insight or confirmed feedback.

1 Accepted Solution

Accepted Solutions

Georg Pauwen
VIP Master VIP Master
VIP Master

Hello,

if the switch loses power, even for only half a second, it will reboot.

View solution in original post

1 Reply 1

Georg Pauwen
VIP Master VIP Master
VIP Master

Hello,

if the switch loses power, even for only half a second, it will reboot.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers