09-18-2002 01:51 PM - edited 03-02-2019 01:27 AM
Hi,
i have 2 routers on a LAN. Router A and Router B.
I'm having problems redistributing a the static route 192.0.80.0 from router
"A" to router "B" via RIP.
Doing a "debug ip rip" on "B" shows RIP routes comming in but does not show
192.0.80.0 comming in.
Doing a "debug ip RIP" on "A" only says "sending v1 update to
255.255.255.255 via FastEthernet0/1 (192.168
.10.100)" - ie no specific info about whats being advertised.
Whats wrong?
Router "A" (12.2 - 2621)
interface FastEthernet0/1
ip address 192.168.10.100 255.255.255.0
load-interval 30
speed 100
full-duplex
no cdp enable
router rip
redistribute static
network 192.168.10.0
ip classless
ip route 0.0.0.0 0.0.0.0 192.168.10.10
ip route 192.0.80.0 255.255.255.0 192.168.10.10
Router "B" (11.0 2501)
interface Ethernet0
ip address 192.168.10.105 255.255.255.0
router rip
network 192.168.10.0
ip route 0.0.0.0 0.0.0.0 192.168.10.10
Solved! Go to Solution.
09-18-2002 07:51 PM
Thanks for that Steve.
I tried that and it made no difference, However I did get it to work using another Topology.
I configured the serial interface on RouterA and connected it to a Frame Network. I changed the static route to point to a fictitious subnet out on the frame.
However a route pointing towards a gateway on the Ethernet side (a third router) still will not advertise for some reason. However I don't need pursue this.
09-18-2002 04:20 PM
On router A, under router rip put default-metric 1 (or 2).
When you redistribute, you should always put default-metric (or the protocol won't understand the other redistributed protocol's metrics).
Hope it helps.
Steve
09-18-2002 07:51 PM
Thanks for that Steve.
I tried that and it made no difference, However I did get it to work using another Topology.
I configured the serial interface on RouterA and connected it to a Frame Network. I changed the static route to point to a fictitious subnet out on the frame.
However a route pointing towards a gateway on the Ethernet side (a third router) still will not advertise for some reason. However I don't need pursue this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide