cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
392
Views
0
Helpful
2
Replies

Remote Access on Switch Supervisor

rsoave
Level 1
Level 1

Hi, I would like to know, if there is any possibility to connect in a Switch Supervisor (Cat 5000, 4000), by a PC with Hyper Terminal, dial up in a modem and connect directly through console port, or another port, if applicable???

Obs: A router in the middle is not applicable, I need to connect directly on switch.

Any help is welcome.

Tks....

1 Accepted Solution

Accepted Solutions

Hello,

yes you can. Check out this link for a detailed configuration description (you need a CCO login to view this document, if you don´t have one post your email address and I´ll send you the document):

http://www.cisco.com/en/US/partner/products/hw/switches/ps679/products_tech_note09186a0080094b30.shtml

Regards,

Georg

View solution in original post

2 Replies 2

Hello,

yes you can. Check out this link for a detailed configuration description (you need a CCO login to view this document, if you don´t have one post your email address and I´ll send you the document):

http://www.cisco.com/en/US/partner/products/hw/switches/ps679/products_tech_note09186a0080094b30.shtml

Regards,

Georg

Very good my friend, this documentation helps me a lot. Next week I will try to implement this solution.

Regards.

Review Cisco Networking for a $25 gift card