I have a 2514 that has two ethernet ports and one serial. The serial link is on a T1 link and the two ethernet ports are plugged into a switch with 2 vlans....of course there are separate networks on them. OK, the problem is I cannot get my to lans that are on the ethernet ports on my router to talk. Here is the router config.
interface Ethernet0
ip address 12.183.xxx.1 255.255.255.0
no cdp enable
!
interface Ethernet1
ip address 12.45.xx.xxx 255.255.255.240
no cdp enable
!
interface Serial0
ip address 12.127.xxx.xx 255.255.255.252
encapsulation ppp
no cdp enable
!
interface Serial1
no ip address
shutdown
no cdp enable
!
ip default-gateway 12.127.xxx.xxx
ip kerberos source-interface any
ip classless
ip route 0.0.0.0 0.0.0.0 12.127.xxx.xx
no ip http server
!
no cdp run
!
!
line con 0
transport input none
line aux 0
line vty 0
password 7
login
length 25
line vty 1 4
password 7
login
!
ntp clock-period 17179847
ntp server 192.5.41.40
ntp server 192.36.133.66
ntp server 128.9.176.30
ntp server 192.6.38.127 prefer
end
Like, I said though, these two subnets plug into the same router, but are on different vlans. I dont think it is a switching issue, but I fealt that this should be known.
Any help will be appreciated.
btw...I can access both of these networks from the Internet, but not from each other.
