cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
330
Views
0
Helpful
1
Replies

service policy on subinterface or main interface

NAVIN PARWAL
Level 2
Level 2

Folks,

We have a frame relay circuit and are applying MQC to the branch sites. We are not sure if we should apply the service policy to the subinterface or the main interface(serial). any pros and cons?

Thanks

1 Reply 1

Adam Frederick
Level 3
Level 3

If you want the same policy applied to each VC then applying at the physical interface would be best (depending on the scenario and how many sub-interfaces you have). In the long run applying the service-policy to the sub-interface will pay for itself.

Review Cisco Networking for a $25 gift card