SNMP configuration in 6006and 4006

[abdulmajeed]

Hai,

We had one 6006 and two 4006 with as many as 10 3548XL switches in our network. We are using a NNM with Ciscoworks2000 for managing the network. We have configured snmp in all switches and hubs in our network.

The problem is:

1. When I try to see the standard reports in ciscoworks2000, I am getting the reports for all catalyst 3548XL Switches. But the reports for 6006 and 4006 are displayed as NO RECORDS, CHECK WHETHER LOGGING IS ENABLE ON THE DEVICE.

2. The configuration done for snmp are

All traps are enable using command

set snmp trap enable all

Logging to the NMS is enabled with the command

set snmp trap X.X.X.X <CommunityName>

The community name I have given is RW community name. What else i have to do to enable logging.

thanz in advance

[milan.kulik]

Hi,

what kind of "standard reports" are you talking about?

I've got a feeling you are concerning Syslog reports.

If yes, you need to enable Syslog messages sending to NMS by

set logging server enable

set logging server x.x.x.x

commands.

Regards,

Milan

[abdulmajeed]

thanz for ur kind reply.

Yes the syslog configuration were done but still I am unable to log even syslog messages.

[milan.kulik]

Well, you have to make the syslog working correctly first.

Here is a step-by-step manual:

http://cco-rtp-1.cisco.com/en/US/customer/products/hw/switches/ps663/products_configuration_guide_chapter09186a00801162f6.html.

Regards,

Milan

[abdulmajeed]

Hi,

Thanz for ur reply. Is a registration cisco id is needed for accessing this site. I have only guest id. could u help me. give me any other link if there is one.

[milan.kulik]

Hi,

try this: http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/7_4/config/logging.pdf

Regards,

Milan

[abdulmajeed]

Hi,

Thanz for ur help. I have read the file and checked it with my configuration. Everything is ok but still I am unable to get the logs in management station.let me know the configuration i have to do to get it working.

thanz