switch harware identification

[seriab]

Mod Port Model Serial # Versions

--- ---- ------------------- ----------- --------------------------------------

1 2 WS-X6K-SUP1A-2GE SAD04460J3K Hw : 7.0

Fw : 5.3(1)

Fw1: 5.4(2)

Sw : 7.2(2)

Sw1: 7.2(2)

What does Fw mean/used for & why they are 2 Fw -- Fw & Fw1..

thanks

[vmiller]

Firmware

[Richard Burts]

Ty

This is a very old thread to try to re-start. You probably would be better off to start a new thread and ask your question as a fresh issue.

In the context of the original post FW is FirmWare. We do not have enough information to give a good answer about fw and fw1. My guess is that there are two different modules/cards each with its own firmware but the display in the original post only contained the slot port model information for the slot with supervisor.

If you have a similar situation then perhaps you could post the output of show module from your switch? If we had a more complete output we might be able to give better answers.

HTH

Rick