08-11-2004 07:26 AM - edited 03-02-2019 05:41 PM
I´m try to make a connection with the "session module # " command to L3 module in a 4006 switch but the mosdule not respond. This module is working and
I was using the outpout intrepeter for check the configuration and modules, but everythings is OK.
This command finction with the another modules in the chassis.
Someone have any idea??????
08-11-2004 07:32 AM
First are you running IOS or CatOS on this switch ?When you perform a "show module" whats status does it say the L3 module is ? Have you rebooted the module ?
08-11-2004 07:44 AM
The swich is running CatOS
The "show module" display "status ok"
I did the reboot of the entire chassis and nothing.
08-11-2004 08:18 AM
are you entering in the correct module number to session over?
Doris (enable)show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok
15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok
9 9 8 1000BaseX Ethernet WS-X6408-GBIC no ok
For instance you would type "session 15" to get to layer 3 virtual module on this one
08-11-2004 08:31 AM
Yes, I´m intro the correct number for the modudle(#3). I not have problem making telnet or connecting by console port to the L3 module.
The problem especificly is with the "session" comand
for this module, because not respond.
Thanks for your help
08-11-2004 08:50 AM
Well then my only advise would be to clear the configs to default, reseat the cards and then try again. If that doesn't work put it into another switch and then if that doesn't work open a TAC case.
08-11-2004 09:06 AM
I´ll do that, is good idea.
08-11-2004 09:50 AM
What CAT OS are you running? We had few bugs in CAT OS
If I were you, I would upgrade to 6.4(11) or 7.6(8) and test
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: