03-29-2020 12:16 PM
Dear all
i have make router as PPPOE server ,
and more of 4000 Client is connected find
but sometime the clinet is stuck and can't connected
i open the wifi-router of one of client (he have problem , his user not connect )
and go to log fine in router
i see this message
May 23 04:25:36 pppd[933]: Timeout waiting for PADO packets May 23 04:25:36 pppd[933]: Unable to complete PPPoE Discovery May 23 04:25:52 pppd[933]: Timeout waiting for PADO packets May 23 04:25:52 pppd[933]: Unable to complete PPPoE Discovery May 23 04:26:04 wireless: ath0 New Access Point/Cell address:B4:FB:E4:DE:59:07 May 23 04:26:08 pppd[933]: Timeout waiting for PADO packets May 23 04:26:08 pppd[933]: Unable to complete PPPoE Discovery
many user have same issues , so they turnoff then turn-on they wifi-router , then they user is conneced
note : i make all my client in same VLan (from router to another switch's )
why some client can't PPPoE Discovery or he dealy ? and how to fix this from router side
some of my config in router
aaa authentication ppp default group radius aaa authorization network default group radius aaa accounting delay-start all aaa accounting nested aaa accounting update periodic 1 aaa accounting network default start-stop group radius aaa accounting system default start-stop group radius aaa server radius dynamic-author client 94.231.199.99 server-key 7 121F0C1517190E05242F342D212031015E44 server-key 7 104D000A0618 auth-type any ignore session-key ignore server-key aaa session-id common ! interface Virtual-Template1 mtu 1460 ip unnumbered Loopback0 no ip redirects ip nat inside ip tcp adjust-mss 1400 ip policy route-map ROUTE-TV no logging event link-status peer default ip address pool interface localpool keepalive 30 ppp authentication chap eap ms-chap ms-chap-v2 pap ppp ipcp dns 8.8.8.8 8.8.4.4 end
03-30-2020 06:23 AM
Hi,
The below messages indicate that the PPPoE client has sent the initial Discovery message, but failed to receive an offer:
May 23 04:25:36 pppd[933]: Timeout waiting for PADO packets May 23 04:25:36 pppd[933]: Unable to complete PPPoE Discovery
So either there is a bug, probably on the PPPoE client side, or there is something happening at layer 2 (like for example are the links towards your routers configured as portfast), or is there anything else in your environment which could affect the layer 2end-to-end connectivity?
Regards,
Cristian Matei.
03-30-2020 11:54 AM
03-31-2020 01:23 AM
Hi,
It has to work, if this happens from time to time, take a closer look at your VPLS environment, at the transport network.
Regards,
Cristian Matei.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide