UBR 900 series DHCP NAT

hypersurf1 · ‎01-21-2003

I am looking for the way(if possible) to get a UBR900 series to pull a dynamic public IP and NAT it to private IP's on a UBR provisioned for one dynamic IP. I use these all the time to run static IP LANS, but have never set one up to pull a DHCP IP from the CMTS. Any help would be greatly appreciated.

Scott

tepatel · ‎01-22-2003

YES..you can configure ubr900 for that. Here is the url with the sample config on that

http://www.cisco.com/warp/customer/109/cable_dhcp_proxy.shtml

hypersurf1 · ‎01-22-2003

yes, i found that late in the morning after hours of searching the web, thank you very much for the reply. all is well now. thanks again for your input.

Scott