Hi,
I currently have an AS5350 with 1 NP60 and 1 2PRI cards. We want to add an NP108 card but I am unsure of 'licensing' or what else I may need when upgrading by adding this card. Any advice on this? Here is the sh ver:
#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 5350 Software (C5350-IS56I-M), Version 12.1(5)XM8, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Thu 21-Feb-02 12:24 by uma
Image text-base: 0x60008968, data-base: 0x61000000
ROM: System Bootstrap, Version 12.2(1r)1, RELEASE SOFTWARE (fc1)
BOOTFLASH: 5350 Software (C5350-BOOT-M), Experimental Version 12.1(20000922:142008) [nag-flo_t_0110 101]
uptime is 1 year, 2 weeks, 5 days, 15 hours, 6 minutes
System returned to ROM by power-on
System restarted at 18:42:37 EDT Thu Jul 31 2003
System image file is "flash:c5350-is56i-mz.121-5.XM8.bin"
cisco AS5350 (R7K) processor (revision O) with 262144K/131072K bytes of memory.
Processor board ID JAE070307F3
R7000 CPU at 250Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x32,
Board Hardware Version 3.34, Item Number 800-5171-02,
Board Revision C0, Serial Number JAE070307F3,
PLD/ISP Version 1.0, Manufacture Date 18-Jan-2003.
Processor 0x14, MAC Address 0x0B468262C4
Backplane HW Revision 1.0, Flash Type 5V
2 FastEthernet/IEEE 802.3 interface(s)
50 Serial network interface(s)
60 terminal line(s)
2 Channelized T1/PRI port(s)
512K bytes of non-volatile configuration memory.
65536K bytes of processor board System flash (Read/Write)
16384K bytes of processor board Boot flash (Read/Write)
Configuration register is 0x2102
