cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
522
Views
0
Helpful
4
Replies

VTP Prunning Betwen VTP Clients

gfiguereo
Beginner
Beginner

i have the following VTP Domain scenario, and i want to configure VTP Prunning for clearing some Vlans .

This configuration is in the 2 Clients.

Can configure Prunning in this 2 client???/

or i need to make this configuration in the VTP Server????

-----=====-------======--------

Server Client Client

4 Replies 4

glen.grant
VIP Alumni
VIP Alumni

You make them on the server if you are using the server,client scenario .

But i don't want to configure the Server.

I only want to prune a trunk link Betwen 2 Clients.

Can i make this configuration Without configure the server???

I will answer this for the sake of future visits on this thread:

In order to enable VTP prunning you need to enable it on only one VTP server (works for VTP v1, v2) or on EACH VTP server switch if you run VTP v3.

This is aplicable for a single VTP domain.

stubinski
Beginner
Beginner

Hi,

If you don't want vlan traffic to cross between the clients you can allow the vlans on the trunk:

switchport trunk [allow/pruning] vlan xxx,xxx,xxx

Hope this helps

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: