cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
282
Views
0
Helpful
1
Replies

What is the best way to CiscoView a cluster and snmp syntax for cluster

msmythe
Level 1
Level 1

Hi All,

I have several clusters using a combination of 2900xl and 3548xl. They use one ip address via the command switch. When I run CiscoView I only see the command switch. What is the correct snmp syntax for CiscoView of cluster? Or is it that I must have an ip address for each member and use stackmaker? Thanks in advance

Mark

1 Reply 1

rmushtaq
Level 8
Level 8

In order to view the XL clusters, you need to use the CMS/CVSM:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/sc/swgcms.htm

Cisco View requires that you assign an individual ip address for each device that you're trying to open up.

Review Cisco Networking for a $25 gift card