01-27-2004 09:17 AM - edited 03-02-2019 01:11 PM
I am trying to Tunnel propriatary Serial data from one device to another accross a WAN via Cisco 2610 routers on each side. Has anyone did this or know where I can find configuration examples for this application?
Thank you
Rick Payne
01-27-2004 02:05 PM
Here's an example of how this can be achieved.
Hope this helps,
02-01-2004 11:32 AM
Rick,
Try this config on both switches
Interface tunnel 0
ip unnumbered ethernet0 <--or interface on internal
tunnel source ethernet0 <--or interface on internal traffic to tunnel
tunnel destination x.x.x.x <--remote router
!
ip route x.x.x.x x.x.x.x tunnel0 <--destination network of tunneled data
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: