2x ASA 5525X: Active with CX License, Standby without
I have the following situation and I am not getting the information from the Cisco documents I have read:
2x ASA5525-SSD120-K9 should be installed in active/standby mode. The question is if it is possible to buy only one CX license for the active one so that it will be more feature rich than the standby one. If a failover occurs the standby ASA will take over but without the CX features of the old active one.
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...