3725 and NM-1T3/E3

[kevin.hart]

Hi

Please help.

I have the following hardware / software

2 x 3725 running 123.12 ipplus

2 x NM-1T3/E3 network module.

The router sees the card - during boot up and via a "show ver"

But doing a "show run" does not provide any serial interface or a controller to configure. What I'm I doing wrong.

I've looked on Cisco's web site and it says that 122-11T is the minimum software required.

I've tried this in both routers using both cards and I get the same results.

Does the 3725 support this card. The manual / web site says so.

[thisisshanky]

There should be a command called "card type E3 or T3" on the global config mode. This will enable the card and a controller T3 should come up on running config. Because this module is capable of T3 or E3, by default the IOS does not set it to T3 or E3. Its a user configurable feature.