09-18-2005 03:37 PM - edited 03-03-2019 12:05 AM
Hi,
We have 2x 3750s in a stack. Over the weekend 1 or both(?) restarted and i don't know why. Where is the best place to start looking?
When i do the sh version, i get
System returned to ROM by power-on
How do i know if it crashed and which switch in the stack actually reset?
I've only just turned trap logging on, so i don't have any data before it restarted.
Thanks,
Joey
09-18-2005 05:14 PM
Your device did not crash - it was either power-cycled, or its power source went down for a few seconds. Check your power source and the outlet circuit (power source to device).
Otherwise you can use the Cisco Output Interpreter (https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl - Cisco.com username/password required): enter the output of show stacks.
HTH,
Josef.
09-18-2005 05:42 PM
Thanks Josef! Looks to me we may have a flaky UPS, lucky it's being replaced soon. Just glad it's not crashing
=)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: