04-17-2005 08:38 PM - edited 03-02-2019 10:29 PM
**********************************************************
* *
* Welcome to Rom Monitor for WS-X4515 System. *
* Copyright (c) 2002 by Cisco Systems, Inc. *
* All rights reserved. *
* *
**********************************************************
Rom Monitor Program Version 12.1(12r)EW
Board type 2, Board revision 7
Swamp FPGA revision 28, Dagobah FPGA revision 86
MAC Address : 00-0c-85-95-8a-01
Ip Address : Not set.
Netmask : Not set.
Gateway : Not set.
TftpServer : Not set.
Main Memory : 512 MBytes
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
. . . . .
******** The system will autoboot now ********
config-register = 0x2102
Autobooting using BOOT variable specified file.....
Current BOOT file is --- bootflash:cat4000-i9s-mz.121-19.EW1.bin
Rommon reg: 0x56004380
Running diags...
Decompressing the image
###############################################################################################################
############################################### [OK]
Unmatched right bracket at /tmp/Exporter.pm line 5, at end of line
syntax error at /tmp/Exporter.pm line 5, near "}"
BEGIN failed--compilation aborted at /tmp/HalLib.pm line 12.
BEGIN failed--compilation aborted at /tm
**********************************************************
* *
* Welcome to Rom Monitor for WS-X4515 System. *
* Copyright (c) 2002 by Cisco Systems, Inc. *
* All rights reserved. *
* *
**********************************************************
Rom Monitor Program Version 12.1(12r)EW
Board type 2, Board revision 7
Swamp FPGA revision 28, Dagobah FPGA revision 86
MAC Address : 00-0c-85-95-8a-01
Ip Address : Not set.
Netmask : Not set.
Gateway : Not set.
TftpServer : Not set.
Main Memory : 512 MBytes
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
. . . . .
******** The system will autoboot now ********
config-register = 0x2102
Autobooting using BOOT variable specified file.....
Current BOOT file is --- bootflash:cat4000-i9s-mz.121-19.EW1.bin
Rommon reg: 0x56004380
Running diags...
Decompressing the image
###############################################################################################################
############################################### [OK]
Unmatched right bracket at /tmp/Exporter.pm line 5, at end of line
syntax error at /tmp/Exporter.pm line 5, near "}"
BEGIN failed--compilation aborted at /tmp/HalLib.pm line 12.
BEGIN failed--compilation aborted at /tm
04-17-2005 10:51 PM
You did not state wheter the problem arose out of the blue or after an upgrade. There are several options:
1: Insuffucient RAM to run this image.
2: Corrupted image in flash
3: Hardware problems.
To alleviate the problem, verify your system requirements, eventually re-enter the image in flash or .. feel free to post additional info when it does not work out.
Regards,
Leo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: