i am tring to setup a 5508. 15 of the 16 aps will be at a remote site
the 5508 will be at HQ (would like this)
at the remote site i have 6 2960-s and a asa5510
this site is a sub site of another site the vlan 1 will be part of the main site which is connected to HQ via VPN.
i think i am missing something maybe a layer 3 switch
i have already gotten 5 of them 3 48port and 2 24 ports there is going to be 1 48 and 1 24 on each floor.
could i just use a L3 switch as a core switch at the site and will i need a L3 switch hat HQ or can i get away with just using the asa that i have at HQ
here is the current setup
internet to bonded T1 to att(cisco 2811)
2811 to asa5510
5510 to netgear FS724TP
internet to T1 to att(cisco 2811)
2811 to asa 5501
to a dum switch
site is connected to HQ via site to site VPN
internet to ASA5510
asa to 2960S(?)
then there will be switches on each floor of the building.
this is kind of like a hotel
each room will have its own vlan
VLAN1 will connect ot the HSV site (mother site) so i can see it form HQ
i would like to have the WLC at HQ and all of the room vlans will go out the asa at the hsv subsite (flexconnect)
It all depends on what do you have the HQ site and HSV Site
- How many devices/users
- Are there servers at any of the locations that I'm assuming users will need access to from the other two sites?
- HSV Site and HSV Subsite are they next to each other, why do you want to get to the HSV Subsite via HSV Site why not directly from the HQ?