cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
153
Views
0
Helpful
4
Replies
Highlighted
Beginner

ACL Manager and device status

I just started using CiscoWorks RWAN suite,I came across ACL Manager, I created a global scenario and check marked "Read Config from Device", however all of the devices I added had the status of "Unreachable" and status detail of "Failed to sync Config Archive with device". What does that mean? The Config Manager in RME works fine. I don't understand what may cause ACL Manager not to synchronize.

4 REPLIES 4
Highlighted
Beginner

Re: ACL Manager and device status

Hi,

Try using those devices in ACLM after updating their configurations in Config Archive. You can do this from Resource Manager Essentials -> Configuration Management -> Update Archive. (Reopen the ACLM scenario after this is done).

Divya

Highlighted
Beginner

Re: ACL Manager and device status

I tried Update Archive, and I got an error message saying that Change Audit process needs to be started. I went into Process Management, stopped the Change Audit process and restarted again. Under Process Status, Change Audit is in the state of "Program started-no mgt msgs received". I still get the same error message that Change Audit process needs to be started. What is the problem here?

Highlighted
Beginner

Re: ACL Manager and device status

try stopping all ciscoworks services and restarting,

net stop crmdmgtd on command line wait 5 minutes and log in,

Highlighted
Beginner

Re: ACL Manager and device status

oopps .. restart ciscoworks - net start crmdmgtd and wait 5 minutes then login...