01-15-2004 07:13 AM - edited 03-02-2019 12:54 PM
hi
I have a remote site with two serial interfaces back to corporate. I need to setup a backup dialer. Is it possible to configure the back up dialer to kick in only when both the circuits are down
thanks
01-15-2004 12:15 PM
I would do it without using the backup interface feature. Use floating statics:
ip route (corportate address) serial0
ip route (corportate address) serial1
ip route (ip address of corporate dialer interface) 255.255.255.255 dialer1
ip route (corportate address) (ip address of corporate dialer interface) 200
As long as either serial line is up, no traffic will be sent to the dialer interace.
If you are using a routing protocol, skip the first two static routes and make sure that the static to the corporate network via the dialer interface has a higher administrative distance than that of your routing protocol.
HTH
Mark
01-16-2004 07:54 AM
Thanks mark
I will try this solution however its going to be next week sometime as i am waiting for an analog line to be installed
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: