Other Network Architecture Subjects

i have only left 4 or 5 hour can anyone please me with this question i am confused...

The design document should include the following sections:1. The introduction: describes the project’s purpose and the reasons for the network design.2. Design Requirements: lists the XYZ organization’s all types of requirements, constraints, and goa...

Resolved! WIC and 'speed' on 2951

Hi all, Best wishes for the new year, may it be safe and outdoors again! For a Cisco 2951 I have a speed issue. The chassis should be able to put 1Gbs through and it does so on the G0/0-G0/2 ports. However teh WIC cards do not go over 250+Mb.. And i ...

Resolved! Standard Ethernet

Hi everyone, I read in the official cisco book that IEEE is the institute that defines the type of cabling, link level protocols, speed rules, etc. while, TIA defines quality standards that it assigns, for example, to a UTP cable. On this last point ...

EIGRP and Balancing Traffic from 2 ISRs to ASA 5525

I have two 3945 ISRs which are hubs in a DMVPN network. They learn the routes of dozens of sites connected over the DMVPN. A redistribution is used take the routes from the AS 201 of the DMVPN to the AS (10) of the HUB to ASA connection. HUB1 redistr...

How Many Services/Features are use ICMP?

How Many Services/Features are use ICMP Protocol and for which purposed?

Cannot ping the natted vip

Hi everyone, I am having a problem so i am not sure if its my nat or the problem is on the F5, Let me give you a picture on the issue , I have two firewalls the internet facing and internal firewall,the proposed project is to have the server access...