Other Network Architecture Subjects

Hello,I have some trouble with vlan mismatch using cdp message. because, port of main siwch configured vlan 100, but port of access switch configured vlan1. thus vlan mismatch message displayed using cdp message. At this time, I'm usally try to chang...

Please see attached pic. In this question, the destination address 10.0.1.15 matches the route in the routing table. But it's the broadcast address within that range. Would the packet still be routed with that route?what would the next hop be? 192.16...

Hi guys,i'm using the latest version of packet tracer (8.0.1) but still getting this problem and i really need the fileif anyone knows how to open it please help !! 

Hi guys,Does anyone have a solid method of calculating supernetting without usng binary conversion?Although I have no problems with binary, I am sure there is a quicker way ;-))ThanksMarc

Hi all,I have a CI I I I router with version 17.09.04a, and need to migrate the configuration from 1941. When I input scheduler allocate, it show "unrecognized command", is it not supported or somethings I missed ?Thanks.

Is there a way on a layer 3 device with multiple IP addresses on it to determine what the logging source-interface is set to? I need to go through and verify settings. Besides just going and running the command on everything I was hoping there was a ...

If you run that command, would future cleartext passwords also be encrypted?

What does this command do? I searched the other forums and found just one reply to a similar request. It was very general and of not much use. I also searched Cisco's web site for this and found no real info. Can anyone tell me if this can be used fo...

I want to use Cisco Configuration Professional Express to access my C829FSP, but it wants credentials.I set it up with the http server (not the secure server).What credentials do I need to set using CLI, in order to access this web portal. I accessed...

Hi All, I have a CSSM server in DC with available licenses. I have few ASR 920 routers in another building which dont have any internet access. Is there any way to license this ASR's without connecting to internet? I do see there is an option to do o...

I am confused about a DHCP config. I have a scenerio where I have two physical ports working as Router on a Stick for the same VLANs on a Cisco router running DHCP. I want both sets of subinterfaces to pull IPs from one set of DHCP pools. From my und...

Greeting everyone,I've been searching for a method to identify the prefixes advertised by BGP without specifying a particular neighbor. Is there any command for this issue ?Thank you