Hi,Looking for suggestions here.I currently manage multiple sites each of which has its own DMZ. E.g. sites in Los Angeles, San Francisco, San Diego, Seattle, etc. mostly along the west coast. Each site hosts its own servers in the DMZ. As a long t...
Forum Posts
Hi,Can someone please let me know what the latest software, firmware and OS is available for the Catalyst 3500XL?ThanksBest regards,Scott
I have a network with a cisco RV110W (i know i know it's out of service) gifted by a friend on 2014, which are connected a couple of wireless hosts and a printer plugged with a print server on parallel port, the only way to communicate with the print...
Since there's nothing much to do at work the day before Christmas, I got bored and thought about checking some old switches in our network and making a list of IOS compilers, as shown in "show version" outputs .Besides prod_rel_team and mcpre (also a...
Hello people,I am testing some QSFP-4X10G-AC10M cables in two C93180YC-FXthe configuration I am using is:CNX-CEN-CI-1-1# show run int Eth1/54!Command: show running-config interface Ethernet1/54!Running configuration last done at: Wed Jul 12 08:00:14 ...
Hi Everyone,I am having the same issue on router configuration. I am getting an error when i run the code ."Router(config-subif)#encapsulation dot1q.90"AND how to complete these tasks. Can some one help here please.
Hi Team, I am trying to connect All vlan in L3 switch to router. I am getting an while running the code . Kindly someone 1 help.
I cannot get into enable mode I get the following error message% Error in authentication.
Hi All,Wanted to know if any software/hardware to reach the internal network (DC devices) when the Anyconnect VPN is down/not reachable.(By passing the VPN so that we can connect for troubleshooting purposes.)
Resolved! how to put DMZ in 3-tier network design
hello,which better design put DMZ with firewall or connect DMZ to distribution switch as shown in image
Hey, I'm experiencing an issue with Packet Tracer 6.0.1. When I try to send any packet over my network I recieve a "Buffer Full" error after so many hops. It gives me the option to clear the buffer but once I do the packet simulation resets. Because ...
Resolved! RADIUS Authentication for telnet?
Is it possible to configure an IOS 12.2 device to authenticate with my RADIUS server instead of TACACS+? I don't have TACACS+ so I've been using just the local logins. I haven't been able to find documentation that indicates this ability.
Resolved! VPLS over GRE Tunnel
I have created the below network setup, trying to get VPLS running over GRE P-P tunnel. The GRE Tunnel is Up. MPLS seems working OK, I can ping from 172.16.18.0 to 172.16.160.0. However, VPLS comes Up (VC is Up) but doesn't forward traffic between si...
Resolved! 2811 router module for BRI interface
In cisco packet tracer, for 2811 router, I am trying to identify the modules (from the module list) for BRI interface. Would anyone please suggest the name of the modules for BRI interface? Thanks.
I replaced my old dhcp-server with the dhcp-function of the sg300.But I didn't know it's full of bugs, like serving ip-address without router, sometimes without dns-server, and sometimes it serves no ip at all. My config is correct, I'm sure. There's...
