Other Network Architecture Subjects

Dear all,we are using RWAN and have a valid maintenance contract for it. We are still confused about the implications of RWAN's EOL. I guesss we will still receive updates and patches for the version we are using, won't we ? But what if upgrades to h...

We have a network of 2 core 6513's Sup2/MSFC2 running Native IOS 12.1(20)E3, there is no separate distribution layer just access layer 'stacks' of 3550's running the SMI image (12.1(20)EA1a). The Core switches are connected together with an 802.1q t...

On a LMS 2.2 instalation that had RME, CM and DFM installed, I have a problem that the CMF says that the installed software for CM and RME has expired it license.RME upgraded to IDU 8 from 5 and CM upgraded to IDU 8 from 7.I uninstalled DFM due to pe...

which commands I can use to get the ipaddress of the system connected to a switch ports.its a cat6509 , i need to find out all the hosts actively connected and thier ipaddress

HiI want to import/update configuration data of the devices registered in my CiscoWorks from another CiscoWorks (both on Windows2k). I found a former feature wich allowed to do so but in newer version this is gone. Is there a workaround for this?THX ...

I have VPN links terminating at a PIX firewall, I want to manage the inside of that firewall from the far side of the VPNCW2k---RTR--VPN 3015 ==== Out PIX In- LANThe PIX has a default rout out to the VPN Tunnel, I can ICMP the outside interface, but ...

How many PoE IP phones can hang off of a Cisco 3750-48 PS and 3750-24 PS switch

Hello all,Output from Ping command on WS-X5302 module running IOS 12.1(20):Sending 200, 1472-byte ICMP Echos to 10.8.100.100, timeout is 2 seconds:!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!...

I can not get output from debug to display on the monitor. Here is the ACL and debug line:access-list 125 permit ip host 170.173.120.2 164.72.0.0 0.0.255.255access-list 125 permit ip 164.72.0.0 0.0.255.255 host 170.173.120.2ROC-3620B-vendor-access#s...

Hi,I'm not sure if anyone is using this or not but I have to ask. Is there a way to configure a job not to schedule a time to run? If we use this I only want it for the config rejection and approval. After it's been approved...I want to add the co...

Is there any benefit for a switch to be reload via the reload command verses a reload via a power cycle?

Hello,We have a very simple network setup. Cisco 2611 with a serial T1. We use only one of the ethernet ports for our internal network.Only have about 15 total machines from a switch that is connected to the ethernet interface of the 2611. OUR PROBLE...

CW is using a DB to store information. I know it stores all device information in there but does it also store all configuration data in the DB too?THX for help

Hi,Can OSPF form adjacencies with HSRP addresses, or does it have to be a physical interface address? What will happen when the standby HSRP router becomes active?Here's what I've got in mind:Suppose I have two border routers connecting via two ether...