hi,everyonedoes Cisco 1721 with enterprise base image support NAT - Ability to Use Route Maps with Static Translations feature?Thanks a lot !Alan.L
hi,everyonedoes Cisco 1721 with enterprise base image support NAT - Ability to Use Route Maps with Static Translations feature?Thanks a lot !Alan.L
i have 2 routers 3640 and 1751 when i configured 1751 to start dial to 3640 not connected but when i made 3640 start dail connected the same case happened in backup to framerelay i try more than 5 differnt conf.please help thanks
Im not too clear with the sequence of process for the ISDN BRI connection to remote end using DDR.From the viewpoint of the router, there is incoming traffic into the router. 1. The dialer-list would check if the traffic is interesting or not.2. If ...
Hello, I am trying to find out for sure if the VWIC-2MFT-T1 card will support ppp multilink. We have a situation where we will be linking 4 T1s between our site and a remote site. I was thinking of placing a 3600 series router at both ends and ...
I have redundant NOKIA Firewall connected to port 2 of two switch with port 12 as trunk. I receive this error:RTD-1-ADDR_FLAP [chars] relearning [dec] addrs per minCisco explanation and solution http://www.cisco.com/en/US/products/hw/switches/ps628/...
Hello all,can someone please confirm the maximum port densities available on a 6509 switch for :1. fibre ports2. 1gb ethernet portsI understande that 2 of the lines are used for the supervisor engine(s) but which modules would tyhen offer me the grte...
Does cisco support BGPV4 4-octet AS number capability advertisement? If yes pls. let me know the supported cisco router/ios and some pointers.Also I want to know similar info on "Carrying label Information" capability advertisement
I have just upgraded to RME3.5 and after that I am not able to do SW distribution.When I do so, I get the following error msg:Error loading image to Flash. Error Info Code: '3627' Message: 'The flash CLI rename operation failed.' ...
I have set up some static vl on a 2950 switch. Now I need to be able to block all broadcasts and any other traffic except for the assigned mac address. Any idea as to how this can be accomplished will be appreciated. I have been told ACL might work b...
I can find physical dimensions of the 3750 switches but I can't locate anywhere the additional depth needed to accommodate the interconnect cables without damage.
I am using a NAM and during a capture and each packet is tagged with a date that is way off. The Catalyst and the Nam dates are accurate. What did I miss?
I'm trying to find any documentation that describes the maximum number of tracked interfaces per HSRP group (or per interface). Having more than 10 tracked interfaces doesn't seem to be a good idea but I'm just looking for any info, if there is.Thank...
I want to limit traffic bound to specific subnets to 10Mbps. Scenarios as belowSource networks are 10.1.1.0/24, 10.1.2.0/24 and 10.1.3.0/24. Where as destination networks are 192.168.1.0/24 and 192.168.2.0/24What I want is, limit the traffic rate for...
hiWhen doing a show frame-relay pvc xx on my frame relay connection running traffic shaping. I see a substanial amt of late-dropped out packets. The link is a satellite link and i run voip over it also. Any suggestions on how to reduce the numbertha...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
Subject | Author | Posted |
---|---|---|
02-20-2024 07:45 AM | ||
02-15-2024 09:08 AM | ||
02-14-2024 04:00 AM | ||
11-10-2023 09:28 AM | ||
11-09-2023 09:30 AM |