we have the two 6500s. One of them is connected into a Cisco 3640 10 MB router. We have set the switch, PacketShaper and router to 10M Half. No errors are showing and all traffic passes. But on the Cisco 3550 switch...IOS ver 12.1(11), the interfa...
If one link on the etherchannel between 7613-1 and 3550-1 is going down, the complette path is changed, to 7613-2 and 3550-27613-1-Root--2x100Mb/sChannel----3550-1| |4xGb/sChannel 1xGb/s| ...
If not all the devices in the network were configured on DNS, Ciscoworks will then discover these devices and list the device name as the IP Address of the device.In Topology services you can delete the device, but when you run another discovery the ...
hi all,just thinking on this ..let say one switch have 2 uplink ports ..can we set one use isl and another use dot1q ...and connect to 2 different routers.cheers,
I was wanting to upgrade my 2950 switch as was wondering if anyone could tell me the most current up to date IOS version for this switch, is it the 12.1(19)? Another question I have is if I should also upgrade the RAM and Flash as well at the same ti...
We did not configure the spanning tree or trunking functions of our C2950-24 switches in the network. Currently we are facing intermittent network timeout issues, e.g. in printing and intranet access. Is this the possible result of not doing this con...
Is it possible to protect the entering into CONFIG MODE by password????Does CISCO IOS allow to create some sort of script to request password before the entering into CONFIG MODE??thanks.
I am running BGP in a multihomed network. Can any body refer me some thing for controlling inbound traffic in BGP. I mean I want to control the preferred downlink between two ISPs
I am a real newbie to Ciscoworks, and I am wondering where to find the device updates for CiscoView when you receive a "Unsupported Card." Please Advice.
Is MD5 authentication in BGP authenticates all types of BGP message, including KEEPALIVE, OPEN? If yes, does it mean that BGP will put the link in down status if the remote router do not have the password set correctly? Thanks
Hi we recently bought a 6513 chassis and we are having some problems with it. It keeps dropping everyone off the network. The Log shows the following enteries. Can anyone help..12:01:40: %PM_SCP-SP-6-LCP_FW_ERR_INFORM: Module 6 is experiencing the fo...
I have a 1760 with an ADSL WIC that I am trying to connect to the Internet (via SBC). They provided a DSL modem but we would rather use the router, using a config I feel 99.99% is correct, every 4 minutes or so, I get the following console message:(D...
This would seem to be a simple question, but it's got me stumped.I have a rogue host on my network. It is sourcing packets apparently from an IP address that is off net: 5.0.3.0. Amongst other things, it is trying to NTP peer with the router, but t...
