Other Network Architecture Subjects

Hi, I would like to get an information how to go about these 2 warnings that alerted. Thanks, Lex

Does anybody know how many hops can be supportted by default on RSTP protocol?

I have a topology to configure with (OSPF 24). I already set ip address for the network. Can please anyone help how to configure this topology using OSPF 24? I dont really sure about how to configure ospf 24. I have attached the packet tracer file he...

Hello,We have a cisco 6509, I see an amber light on the system led at the supervisor engine. Anybody would know how to identify the problem.Your help is very much appreciated.Wajma

Hello Everyone, We are in process of IOS upgrade of our 2 Nexus 9504 switches. I have one query about upgrade procedure though I've followed all the instructions given in Cisco doc. Both 2 switches have standby SUP engine. Is there any separate proce...

How much does it cost to avail of CISCO's services in migrating an IBM AS400 Machine into having/using an SNA over TCP/IP network that communicates with ATM machines and other machines as well. The IBM AS400 has V5R3M0 and the IBM AS400 machine model...

Hello, We are migrating from Cisco CSS to netscalers. I had a question in this. My old CSS configs had bridge vlan and circuits. How do I interpret this in Netscalers? Please feel free to move to appropriate forum. 

Is there a location on the Cisco support community or FAQs where Cisco defines best practices or recommended reboot times for their products?

I have to configure switch in packet tracer using CLI command. I have done setting the root port. But I don't know how to configure switch to block some ports. I have attached the questions here. Can anyone let me know how to configure, and let know ...

Looking for industrial grade switches for warehouse (non-air/dust/dirt). Need to run fiber to extend past 300 ft. Cost is an issue, thanks in advance.

Product/Model Number : AIR-LAP1142N-A-K9 k9w7 firmware: c1140-k9w7-mx.152-2.JA1 Mode recovery, installed standalone firmware successfully. Boot.. Here is the console message: \0x00 using eeprom values WRDTR,CLKTR: 0x85000800 0x40000000 RQDC ,RFDC...