Other Network Architecture Subjects

Hello all,I have a requirement to configure Netflow on a Cisco ISR 4331 (17.06.04). Exporting Netflow to the collector is not a problem.However, I would like to filter the SNMP traffic (maybe via ACL) not to send via Netflow to the collector.Is there...

I am having problems accessing the router through the computer through SSH, I applied the settings on the router but I am not succeeding when entering the command "ssh -1 cartola 192.168.0.254". Username: cartola Password:cartola Secret: cartola

Hi Gurus,I have turned off the command, no service finger but somehow it is not displaying at the running config.How can i do it?The reason I am asking is because there is new switch where i need to config based on whatever is turned off. How can I s...

HI,I have a rotuer C8000v generating s lot of error messages like these:030239: Mar 16 01:43:07: %BTRACE_MANAGER-3-BTRT_ERR_MSG: R0/0: btman: Btrace Rotate Error: Move file failed, Delete file: plogd_R0-0.12265_37746.20230316004150.bin.gz030240: Mar ...

OK. I am having an issue adding a new devise to my Prime infrastructure that I cannot figure out. I am getting a message that says the following when I try to add a new router....               Device Creation #.#.#.# failed. IP address is not unique...

My question is the same as the title and I wrote down what I understood below. If there is something wrong, could you explain the wrong part and contents? 1. sso has active RP and standby RP2. If RP failed, active RP dies and standby RP takes its pla...

Hi team, for some reason my cisco asa stopped sending logs to the syslog server. i have tried to disable and enable the logging again, removed the syslog server from the ASDM and added again using the logging host command  but still nothin, and when ...

We are designing a new industrial network and are planning to use PRP for redundancy. The network will span between different sites and the two involved WAN links, A and B, will have different latency. By design recommendations, I'm aware of the use ...

IE-1000-8P2S-LM has a long lead time. Which switch model would be the equivalent? The physical dimension is also a big factor. 

All,I am trying to configure my Cisco Nexus 93180YC-EX as a PTP Boundary clock. I've configured PTP globally and set the clock protocol to use PTP. My Grand Master clock is a Qulsar Qg2 currently outputting a multicast PTPv2 protocol. Using a port mi...

Hi,which course I need to take for the network designing part, especially HLD LLD. Please suggest. 

Hello. I’m not sure if this is the correct sub-forum or not. Apologies. I have a Cisco CBS110-24T unmanaged switch that has two mini-gbic SFP ports. This is the “compact” version of the switch without onboard PoE (the PoE model is a full 1RU, and I h...