Other Network Architecture Subjects

Provide full internet access with MAC ID.

Hi I have a problem, I have a switch 6509 with two supervisors, one of them was with alarm, so I entered to the device by console, and it was in mode rommon, so what I did was to make that load the image, after I rebooted the device, all the led turn...

I uploaded the most current firmware on the phone. It will show a TFTP file error on phone display when booting up. I'm assuming the firmware did not upload correctly. I tried reloading the firmware and it shows the same issue. How do I completely er...

With reference to cisco's document on BGP Best Path Selection Algorithm (http://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13753-25.html). Out of given 9 paths why 6th has been selected even though AS_PATH for 8th route is bett...

I have a 3500 seater capacity auditorium, how many air-cap-3602e-n-k9 access points do I need?

I have this issue on one of my asr9k routers.  pmo4 & pmo12.  re-seating these made no difference.  so swapped pmo4 with pmo0 and pmo12 with pmo8.  I am now seeing alarms for pmo0 and pmo8 should I be looking to replace these pmo's ?

Hi,Which is the best traffic load balancer, with 3-4 WAN ports and 1 LAN? what is your experience with it? Does Cisco have any equipment that performs load balancing? What are other vendors options?Best regards,Brj 

Incase of traffic policing, for a particular class if the violate action is set to transmit and *not* drop then will the packets still be dropped?

Hi,Can i use my WAN interface ip as the GRE tunnel source ip in my cisco router.Is there any issue if i'am assigning a private ip to the GRE tunnel interface.

I had missed the above session due to unexpected emergency calls. REquest you to upload the videos at the earliest

Hello,I have stacked 6, 2960x switches with the supplied 0.5m FlexStack cables, however my "sh switch detail" doesn't match up to how it's cabled. I found documentation on how to cable 4 of them with 0.5m cables, but not 6. Could anyone explain or po...

Dear All,   I had tried IPsec with fast Ethernet 0/1 it works fine but when i tried to map same ipsec crypto to tunnel1 {VTI} interface IPsec not working. My remote Site checks for source IP of fast Ethernet 0/0 {Proxy ID in Juniper} I tried to MAP c...