Other Network Architecture Subjects

Is there a way of importing CM seeds by the use of a file?I have approx 800 seperate sites with a total of up to 6000 devices, but no CDP running across the backbone (or between some sites), so need to enter all the site seeds.Any ideas on automating...

Hi all,The following scenario:e0--R1-----R2--e0R1 peer R2 with DLSW, And I want R1not send netbios explore frame to R2 and R2 not send netbios explore frame to R1.So Can I use a netbios access-list in the e0 interface to bar the netbios packet so tha...

Doesn't Cisco Work (and Cisco View) for win 6.1have any support for Cisco 4506? I can´t find any new device supported package on Cisco-web.Will that be supported?It is only Cat4000 wich is in the device supprted package.

Doesn't Cisco Work (and Cisco View) have any support for Cisco 6400?I have searched on the CCO, with no result.

Does anyone knows the MAC address table capacity of CAt3550 switch? I encountered a problem whereby after sometime my users cannot login anymore. All the LEDs are ok and no error on the switch.

Hi,I'm trying to route between 2 6509's using Gige, fiber. Trunking is turned off, a traffic Vlan is configured on each side with associated routed interfaces on each swtich with same IP subnet. Everything looks great from a routing perpsective exc...

(router1)-----------------(router2)------------------(router3)router 1 have a serial link to router2 backed up by isdn line, so do router 2 to router3 . is it possible to make router3 dial router 1 if link between router 2 and router 1 is downwith re...

We just replaced an old 2500 with a new 2621XM. The thing is, the old 2500 would log to a syslog everytime a DLCI's status changed from "ACTIVE to INACTIVE or DELETED", but since the new 2621 has been in place, it hasn't logged any DLCI changes. Th...

I have just brought up additional sites that connect to my main site where my Internet router (cisco 2611) and PIX 506e reside. The new sites connect to the main site via a cisco 1760. Everything at the main site uses the PIX address as the default...

Anyone ever heard an an upgrade that will make a 1924 run IOS??

HiDoes any one knows a way to monitor a rate-limit (bytes conformed, bytes dropped, etc) and access-lists (matches) through a SNMP monitoring application such as MRTG???TIA

I have a 3640, IOS 12.2.12a and every now and then I get a user calling me for help as they are being dialled back continueously every minute even when there is no PC attached to the phone. The dialer shows a huge number of failed attempts. The only ...

Hi all, Please help me choose a router for these goals below:- Using 10 ports Fast Ethernet for LAN- Using 1 port for Frame Relay connection ( 512 Kbps - 1 Mbps )- Using 6 port voice over Frame relay ( E and M )Thank you very muchNguyen Manh Hung