Other Network Architecture Subjects

What process is VUR MGR on WS-C3550-12T switch/router? It hits 100 % cpu hit until routing table being manually cleared ? Mar 10 10:32:09 CCT: %SYS-3-CPUHOG: Task ran for 4892 msec (2/0), process = VUR_MGR bg process, PC = 188994.I was not able to f...

When I installed LMS 2.1 quite a few of the hosts didn't have an entry in the DNS server, I've now added all the relevant entries. Will RME find the DNS name rather than the IP address or will I need to remove then add each device?

Can someone confirm to me that the only way to get configs downloaded from PIX firewalls is via telnet? If trying via SNMP when SNMP connectivity has already been proven you get a " cannot connect to host" error.Thanks in advance.Nick

Could someone explain the purpose of the nat outside statement on the BVI1 interface in this config. when there is already a nat inside on E1?no service padservice timestamps debug uptimeservice timestamps log uptimeservice password-encryption!hostna...

Hi,I need to lock one of the Ethernet interfaces on a router to a specific MAC address so only one device is allowed to use it. I haven't been able to find any way in which the ACL enables filtering on MAC address.Any ideas please ?Thanks.

Hi All,Does any body know the real difference between point-to-point and multipoint interface type? I just know that when you use point-to-point in frame-relay etc, you can not connect to two peers (so in frame-relay, you can just config 1 virtual-ci...

I have a cisco 3662 router with 2 WAN ports and 2 FE portsI have connected two isps on my WAN ports to FE 0/1 using route-map command successfullyBut I when try to connect a RJ-45 cable form a ADSL ATU-R modem to my cisco 3662 FE0/1 port , I have p...

I have a customer who wants to have users connect to an as5300 which has a t1 connected to it, then be able to dial out to a remote site. I guess the as5300 would be in a sense a modem pool. Can the as5300 do this and if so does anyone have any confi...

Trying to put together some software to report on utilization of servers for a customer that does not want ITEM. The problem I am running into is that I do not seem to be able to get the Call Manager server running 3.2.2c to respond to snmp mib walk...

Greetings everyone,DFM 1.1 reports discovery error due to an incorrect community string. I've corrected the community string and cleared the alarms but discovery still does not work. It seems to insist on using the old string.Running CWLMS-2.0 on a W...

Hi guys and gals,I'm trying to figure out how I can connect my 2514 serial port to an external 56K modem. I've found a few cables, which convert DB60/DB25. If I'm not mistaken, the DB25 will be the DCE and the DB60 will be the DTE. Herein lies the...

I would like to know if catalysts 1900,2900XL and 5000 stand Rapid STP.I have to implement this feature in a customer and I did not find anything on Cisco pagerelating this feature with these equipments.Thanks,Antonio

Dear All,According to SAFE architecture notes, “Avoid using VLANs as the sole method of securing access between two subnets" Does this mean that instead of assigning the router to do the routing between VLANs I have to assign the FW to isolate betwee...