Other Network Architecture Subjects

HiI'm doing some tests and labs on my own and I've got a single 2501 router and I wonder if there's some kind of mediaconverter or transceiver for the Serial port on the router. I wish to be able to directly connect to a CISCO 3512XL switch through t...

Hi! I installed the ciscoworks2000 edition 5.0 on my server.But my ciscoview can't open any device.It show me like this "resulting class definition does not exist on server! com.cisco.nm.cvw.devpkgs.catqdm.descriptorincompatibility may exist amon...

Is there any good cisco link where I can learn about the design and configure aspects of Cisco 7206VXR and Cisco 3745 products for both data and voice.

I am designing Network Management Networks and I need to know how much bandwidth I will need to supervise my devices.The devices are routers and switches.The NMS are Cisco WAN Mgt and Cisco LMS.I usually have two routers and 4 switches per site.Does ...

Oh my god!! I'm stuck in ROMMON> mode on my brand new 4006 and I don't know how to restore it? This is what I'm seeing...rommon 14 >dir bootflash: File size Checksum File name 4118704 bytes (0x3ed8b0) 0xed1d46d7 cat4000.6...

Scenario:What I’m trying to do is setup a layer1 to layer 3 connectivity between 1600 T1 router and GSR DS3 line card (6DS3-SMB line card – 6 port packet over DS3) using ADTRAN mx2800 MUX (T3 to T1 MUX) in between. Here is the Cisco link for line ca...

Hello everyone,I am new to Campus manager. I am trying to get it to discover our network topolgy which consist of various router, IP phones and various switches. I have added a seeding device and evetered teh snpm info into the server confi but it ...

Peculiar problem. Experiencing while load-balancing with BGP, finding the traffic not load balancing with the Next Hop as IP configured. Whereas smooth functioning with Next Hop as Interface configured. What could be the reason. RegardsK. Sadagopan

What is command syntax for enableing encryption on cisco 2950?

I am trying to use the "Monitor" feature in Ciscoview. I see Real-time traffic, how long will these utilisation be stored? ie, am I only able to view traffic for 5 mins? If not, what is the maximum duration? Pls help, thanks.

i am trying to load IOS on 3640 router through xmodem procedure because the router is enable to boot from the existing IOS file and runs in the RomMonitor mode. The process of IOS loading starts through xmodem procedure but after the transfer of 99kB...

I am trying to find a system that can control up/down state of Catalyst 4000 ports and even shut down routing interfaces on that device. This Catalyst will be installed in a conference center, and the various rooms can be reserved well in advance of ...