We have recently upgraded all our WAN router to Cisco 3945, they all have the same FLOW config as below but when I do a sh flow export statisticson some routers I get:Flow Exporter Export-FNF-Plixer: Packet send statistics (last cleared 1d08h ...
I configured ip sla video probes on 2951 to send probes to 3945, but it seems that i meet some problems, can anyone help me?1.Device version information:nmtgs2951a#sh verCisco IOS Software, C2951 Software (C2951-UNIVERSALK9-M), Version 15.2(2)T1, REL...
Hi,We are in the process of trialling VMWare View virtual desktop with Windows 8 as the os.Ignore the VM side of things for now, Im trying to get it to work on my laptop with Windows 8.Jabber works well, but the medianet msi fails to install. "Cisco ...
Hi all,I recently bought Cisco Prime NCS and got its license file as well from cisco and upload it but Prime NCS is still showing Unlicensed do any one else have similar issue. what i should do now. Cisco help is very slow.
We have been having recurring problems at three of our new school sites with printer IP addresses. We have created the address reservations in our DHCP servers (Windows Server 2012) but several times per week, the address shows up as a "BAD ADDRESS" ...
I am trying to get into ROM mode into this 2500 router but there is not display of anything and then shows the message "Press RETURN to get started" all of the boot up information from boot loader is not displayed. I send the ctrl-break but nothing h...
Does anyone have any information on Packets/Second for FireEye appliances? Not performance of analysis for Malware, attacks, etc, just overall simple how many packets can it process while inline before dropping packets.I have been...
We are currently trying to improve our network traffic testing setup, to achieve playback of our samples across the network at 20GB/s We have recently installed a NAS which can run tcpreplay, along with an Intel x520 fibre card with 2 10Gb/s SFP port...
Hi,I have a 3750-X that is configured to log to a syslog server. When I issue the 'show logging' command, the output tells me that the link is 'up' as shown belowLogging to 172.20.1.1 (udp port 514, audit disabled,
authentication disabled, en...
Hi, I have a scenario where a customer requires the use of WoL over the WAN to waken PCs located on 100 remote sites. There are two servers sending the magic packets located in a data centre. One of these can use subnet directed broadcasts the other ...
Hello Cisco speciallists , Im planing to make major changes on my Lan-to-Lan configurations.Currently Im sending non tagged traffic from my Site1 to my Site2 over my service provider backhaul.Now I need to tag this traffic so I will change from a por...
Hello everyone!We want to upgrade our server network, make it more failover. We have two 3750 switch and several servers.So, what are the best practices failover network?I watched into direction of HSRP and LACP.1st case:switches use master/standby H...
I would like to restrict bandwidth on specific interface which is connected to customer end router my intention is to allocate only 10mb bandwidth in cisco 2960 switchSome existing configs as follows#mls qos map cos-dscp 0 8 16 26 32 46 48 56#mls qos...
While learning how to use my Cisco 851W router, I downloaded a configuration script with preconfigured settings. I ran this from the router and now I can no longer boot up and get to a command prompt.I have tried holding the reset button while turnin...
