Other Network Architecture Subjects

I am looking for documentation on:If a router has 20 equal cost routing paths and only 4 show up in the routing table, what is the determining factor that chooses which four and where are the other 16 put in case the 4 routes become unusable.Most doc...

I have a couple of questions. I am looking into trialing these routers for a vehicle environment. Currently we are trialing a CalAmp Fusion that has a 4G connection with wireless lan, Lan switch and with GPS on the unit. The problem with this setup i...

Environment:Web Server inside and 10 internal workstations.One external public IP address.Cisco Router 806 with HTTP server enable.Conditions:External users have to be able to access the web server.The internal users have to be able to access the we...

hi all,i know this is not the correct subject to post this, but i dont have access to the "CCENT" subjects.so feel free to move this post if youre an moderator.i want to begin with my certification to the CCENT > ICND1 > ICND2 ectso ive been looking ...

http://www.cisco.com/en/US/docs/ios/termserv/command/reference/tsv_cr_book.pdfTSV-148Cisco IOS Terminal Services commandsJuly 2011Modem stateModem control state. Although the sample output shows the modem stateIdle, this field should always say READY...

Hi I have an RV 180W. Problem is that I'd like to forward a range of ports but cannot seem to achieve this. One minute the router is forwarding and the next the port is closed. Some of these are custom ports while others like ftp behave in the same w...

Hi All,I am trying to understand cisco QoS techniques. I came to know that queueing techniques is used(or comes alive) only when you experience conjestion on your network. Here I am a little confused with a few scenarios in front of me. I am trying t...

We currently have a QoS policy as per configuration below:!!policy-map QOS_POLICYclass VOICE  set dscp ef   police cir 12800 bc 8000     conform-action transmit     exceed-action drop!!I wanted to increase the CIR, the BC and also change the exceed a...

I have these two design choices in my hand. Scenario 1 was pretty our #1 choice until someone throwed Scenario 2 on the table and now our manager would like to get from me which one should we implement. To me Scenario #1 and #2 are very similar but h...

The new c1140-k9w7-tar.152-4.JA1.tar update appears to be broken. It fixes the old, old problem of allowing a PPTP VPN to pass through, but now the ssid manager in the security menu doesn't work anymore. It fails to show any ssid that is created, or ...

I have spent a while looking around, done alot of reading and havent been able to get my lab to work.I am trying to get the a router to assign the privalge level based on a Windows group using Microsoft NPS (latest incarnation of IAS).So I done alot ...

Need suggestion, what a difference between GLC-LH-SMD and GLC-LH-SMD=  and would it possible whether GLC-LH-SM replaced with GLC-LH-SMD=Thanks you.Teerawat K.

Do the Cisco 887VA-W support fibre connections?                  

                   We have enabled Medianet on our N/W infrastructure along with the EX60 end points. In addition installed PCM to capture the logs and details of the Medianet traces.On the PCM, we are able to discover, manage the endpoints. However ...