Other Network Architecture Subjects

Hi,If the Ciscworks and the HPOV is NATed by the router to poll the SNMP device on the "NAT outside" interface, can the Ciscoworks and HPOV polls the device and recevice the trap and syslog?"CiscoWorks + HPOV" --- (NAT inside) Router(NAT Outside) --...

I'm working with one of our local government accounts that is using the 3005, IOS 3.6.5. The VPN Concentrator fails like clockwork every 24 hours. The vpn box does not loose its address or show any errors. All they have to do is disable the outsid...

I have a 1005 router I attempting to use for internet connectivity at home.I am using IOS ver 12.1(17). Problem is that when I use "physical-interface async" at the config-if prompt. I get "unknown physical interface" I was under the impression th...

Hi,Mulit-VRF is supported in Cat3550-48. Could you advise the max number of vrf is supported? For example, each vrf contains around 200 routes.Thanks,Cliff

can i have two area border routers for the same area( ex. area 1), and if i can have so..must they be physically connected by a link that resides in area 1.??how will another area border router in (area zero) will route traffic destined to networks i...

I have installed CW2K 5th Edition on an HPOV NNM 6.2 server running Solaris 2.8 but am having major integration issues between the two applications. None of the applications under the Cisco Applications menu appear to work, but are also not generati...

If I enable PPPoE on the Fastethernet Interface of my router, how can I restrict people from configuring a static IP from the subnet or secondary subnet on the FE interface? I want to force them to PPPoE.

I try to use 32MB CompactFlash card with PCMCIA adapter for Cisco3662/3640, cisco detects this card, but show that it's size - 0Kb. It doesn't permit do "erase slot0:", "squ slot0:" and other commands. Is it hardware incompatibility or may be i shoul...

MY customer are interested abouted cisco 4507R , but he want netflow feature

Can I connect two 3550-12G switches (routers in my scenario) using GigabitEthernet interfaces configured for L3 operation ("no switchport" command). This what I want achieve ist in fact direct router to router connection? Will inerface GE with "no s...

My Router 3600 is forwarding the broadcast packet to the remote subnet .How to disable it?

DOes HSRP supported on low-end Cisco routers such as 805/ 1600/1700 ?

Hi AllMerry XmasPlease I keep getting this alerts - High Queue Drope Rate from the DFM in CiscoWorks as per Performnace Exception. From the Cisco web site, it says there might be a problem with a NIC. But how do I get to know which port on he switch...

I recently installed LMS 2.1 - my network has the following equipment : Core 2 * cat 6513 , 2 * cat 4006 and access switches are 1900/2900/2950/3500 - I can see all the devices except the cat 4006 - - comes up on the campus manager as unknown - I am ...

Hi All,Cisco Works RME on Solaris.Suddenly when i log in to RME , I am not able to see my devices .Under process failure it says essentialsdbmonitor not running.When i run the self test it gives the output that cannot connect to databse.Help need urg...