Other Network Architecture Subjects

Hello,I've a cisco 2503 running ios c2500-i-l.120-22When the cisco dials to the ISP CHAP authentication is OK but IPCP addres negotiation is going wrong. What can be wrong in my configuration?See attached debugging output and configuration.Thanks.Hen...

Is it possible to configure VC's on a POS adapter like the PA-POS-OC3SMI?

Hi,I'm experiencing a strange problem with an Access Server (Cisco 3640, IOS 12.2(3))I have a PRI on the router that accepts dial-up connections (most of them ISDN).The access server runs EBGP and OSPF with other routers within the AS.Some dial-in co...

I am upgrading from an 8mb flash to a 32mb flash. from the rommon prompt I can not see the flash. If I load an ios into dram I can see the flash but I get an error trying to write the ios to the flash. Any ideas?

Running CW2000 LMS 2.0, scheduled incremental device support does not function properly. Event log says"[08/02/2002 07:45:42.859] INFO: Snchronization of local repository started.[08/02/2002 07:45:43.171] INFO: Memory Usage: used=5.56 MB, total=9.00 ...

Hi RIZWAN, I wan to install the NAM Strong Crypto Patch, but I can not find it on cisco.com or ftp.cisco.com. Where is it? Thanks a lot :)

Does anyone know if its possible to increase the bandwidth on an IP tunnel from the default 9k?

I've had the assistance of 2 CCIE's and have not been able to come to a resolution on getting this router to connect to SBC Internet Service. Below are samples of configs I've tried, but they haven't worked.If ANY insight can be provided as to how t...

I have an NFAS group configuration of 4 channelized T1s. serial 0 carries the primary d-channel, serial 1 carries the secondary, two and three care 24 B interfaces. If I lose serial, who carries my secondary d-channel, will the other 3 T1s be opera...

This is the sample of "show diag" output of GSR12008.If you write the serial number of the Route Processor,which serial number you will choose?it's s/n of PCA,or of MBUS,and what are PCA and MBUS.Thx!SLOT 0 (RP/LC 0 ): Route Processor MAIN: type 19...

Hi,My router seems to keeps showing a strange register value even after I change it manually.Anybody have any ideas what could be wrong?R1#conf tEnter configuration commands, one per line. End with CNTL/Z.R1(config)#config-register 0x2102R1(config)#...

Does AS5300 w/MICA2 modemcard support V.92 and HSCSD (GSM highspeed data)? What is the latest stable IOS for AS5300? I guess S53C-12105T should be ok? Thanks.

I have two locations each with its own 1210 router with WIC-1T cards in them.They are connected together by a T1 (PPP) . I am fairly new to the Cisco IOS commands but where I have a problem is I don't know where to start with the configuring, this i...

We recently had a security scan which picked up that TCP Port 1999 was administratively prohibited. Further analysis indicated that an ACL on our ISP's router (Cisco 2500 on 11.3) is filtering any host communicating with the router on TCP Port 1999...

What is the ISO-defined functional areas of network management?And where can i find related technical documents?