Other Network Architecture Subjects

Ok, so maybe the title is a little confusing. But, this is what i need to know how to do.I was wondering if there is a way to configure a 2900 switch port to only allow it to access one IP address. Basically I want a user that is cable connected to ...

Does a 2600 router support BGP? I am looking at doing this with my T provider. I have 2 2600 routers, I will have a T going to each. I want the provider to be able to automatically sense if one or the other is down and reroute traffic accordingly....

I can save on a tftp server or inject into a router the contents of the startup configuration with the commands "Copy startup-config tftp:" or "Copy tftp: startup-config".But i use these commands on the router. Is there a means to make these o...

Is there an adapter for Network Node Manager 6.1 availabe in the CD One 5th Edition install? We are upgrading from LMS 1.1 to 1.2 and would like to integrate with NNM 6.1.TIA.

After i upgrade my nam modules to version 1.2(3) i can't log in via http access.I already typed the command ip http server enable , but the nammodule doesn't recognise this command. I even reset the modules several times but nothing works. Someone w...

Anyone know of any 3rd party NetFlow analysis/collection software available?

Dear Sir!I've two process domain router igrp 100 & router igrp 200 configured on border router. Is there automatic redistribution for TWO DIFFERENT IGRP DOMAINS?Nick

I am moving to a different Frame relay circuit provider, and I would like to have both circuits up and running concurrently, yet only move over to the new circuit when the old circuit is removed, kind of like a failover.The host router is a 3640 and ...

Currently, we have a Cisco 7206 router with 1 FastEthernet interface configured for with an IP from a routable subnet we use. There is another routable block [Class C] that we split into 4 /26 blocks. We want to use 2 of these /26 blocks on the this ...

We have a customer with an NM-8AS module installed in a 3640 router acting as a distribution node , this node has become unstable and on investigation we discovered that the customer has higher speed links than 128k connected to this module. We are...

Hi,Can I use the 5483 GBIC module with the 2948G-L3? The 2948G-L3 switch has 2 GBIC slots, can I use the two slots for the 5483 GBIC module?

I have a cisco 7204 VXR router with IOS 12.1.(1a) and 64MB of RAM. There are 8 serial interfaces connected to this router. The problem im facing is that this router hangs intermittently and goes to the boot mode.Then i have to turn off the router for...

I had a fully functional 2512 (old token ring terminal server) yesterday but today after a cold reboot it hangs at (with the config register set to 0x2102):System Bootstrap, Version 11.0(10c)XB1, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1)Copyright (c) ...

HelloIs there a simpler way to allow only IP Traffic on a serial link instead of applying access-lists of each protocol which sould be denyed?RegardsLouis

What is singlemode extended range (1000Base-ZX) ?? Comparing with 1000 SX/LX/TX ??