Other Network Architecture Subjects

i am using Ciscoworks2K 2nd edition on windows NT 4.0 server SP5 ... and i try to discover my network ... aniserver perform a good discovery but it's unable to resolve IP addresse to name ( in the hosts file because l have no DNS). Can you help me p...

Hi.I'm configuring a CISCO 801 to work with Frame-relay over B channel. This is a part of my configuration , I think that it's good but it doesn't work. Can you find some mistake ?frame-relay switchinginterface Dialer4 description Acceso AUTO ip ad...

When I execute a 'show isdn active' command on a 1600 series router, the final column is 'Charges Units/Currency' which is currently blank. How do I configure my router so that this column shows me the cost of the ISDN call instead of being blank?Hop...

Does the 3550 support GRE and if not when will it?

Does anyone know where I can find the pinouts to make a HSSI crossover cable so that I can connect two 2691routers together through there HSSI interfaces to simulate a WAN cloud to use as a test lab? Thanks.

Hi, I have a customer that has some strange problems on a ISDN Line, attached to a Cisco 1751. Does anyone has some idea about the meaning of the "MPH_EI2_IND" message?Thanks,Leonardo00:11:33: ISDN BR1/0: L1 ERR IF_ACTIVE00:11:33: ISDN BR1/0: Recvd ...

when i config " ip helper-address ..." command, the router can take the role of dhcp relay agent. but if the interface has two ip addresses configued,what i need know is that, when routers forward dhcp discovery packets, which address will be used as...

I have a 1700 series router with a internal csu/dsu 56k, when I do a show service module I see oos/oof incrementing. I looked on cisco web site and I could not find any explanation of what a oos/oof means, I appreciate it if someone can share some li...

Hi, I receive following errors incrementing for two different BXM cards on a BPX when I use the dspbxmsloterrs . Please help me interprete the type of errors and the fix :dspbxmsloterrs 3 ( bxm-155 rev EDD)CelMem Pyld P Errs 154K dspbxmsloterrs 6 ...

Hello there,I have a 7206VXR that acts as an aggregator for several Cisco DSLAMs through an STM-1 port and an 8xE1 IMA port; OSPF is the running protocol. I had several incidents recently where those DSLAMs connected to the IMA card seemed to get det...

Hi, we want to connect remote offices to the internet .We have a C3620 with subinterfaces for each remote office , these offices are connected to the main office by wireless connection. We can ping and tracert from each office to any site after ...

A NAT-enabled router can allow some users to utilize NAT and allow other users on the same Ethernet interface to continue with their own IP addresses.For example,ip nat pool satellites 53.253.66.209 53.253.66.254 netmask 255.255.255.192ip nat inside ...

What do you guys recomment for general deployment/stable IOS/Catos for a 2948G, 6509 w/Sup1 card, and a AS5300 ?TIA,Mitch

HiWhat is the diffrence between the Universal Port tand Ultra Port in AS5350?Thank you

An 806 running 12.2(8)T5 wouldn't negotiate a connection to a hard-set 10-meg port on a Cat4006 (with an xover cable) so I started looking at the router interface... Even when unplugged, it shows Up/Down. Is this caused by the E1 port being PPPoE ca...