Other Network Architecture Subjects

As the title states I have a Catalyst 3548 switch that I suspect is bogging down. In the middle of the day I will change the mode to utilization and the LED's are green to about port 30 and amber the rest of the way up. I haven't been able to find ...

What command is used to remove a port channel that was setup on a 6509? I believe that it is done by the command "set port channel 2/16 mode off". After running this command I used "show channel" - 2/16 no longer appears. However, after running the "...

Hi:I've got a 2900XL Catalyst which I'm wanting to configure using Rate-limit and Access-list commands.Currently I access the switch using browser access & a password.Telnet access has been disabled by my boss (for security).If I try to telnet into t...

I have 6 Microsoft IIS servers with 2 NIC's in each server. The two NIC's are for redundancy. The active NIC broadcast a layer 2 broadcast every 2 seconds so the inactive NIC will see the active NIC is operational.Since this broadcast traffic is kill...

I am trying to set up a 2651to route between two vlans on a single interface. I don't get the option for the encapsulation command at the subinterface?Here is the version info:IOS (tm) C2600 Software (C2600-I-M), Version 12.2(5d)Am I missing somethi...

Hi,I have the need for some 1000BASE-T port on one of our CAT 55509.The CAT is equipped with two WS-X5410 9 port cards.In the documentation for the new GBIC WS-G5483 I can see nothing related to the CAT 5500 series of switches. When inserting the GBI...

HI All. Can somebody give me some info regarding Route Refresh in respect to BGP.Thanks in AdvanceRegardsAditya KaulSify India

I have a situaton where i have to bridge Ethernet traffic over frame-relay multipoint interface. The Router is connected to 3 spoke sites and all connected through same Multipoint interface.How do i do this ? I have Map statements for briding etc and...

I need documentation about to how to setup an AAA server using RADIUS and/or TACACS+ protocols?, it is a freeware application that i can download and install in a Windows NT machine?. Thanks.

I have several 5300 and 5400 access servers running in our networkusing the mib .1.3.6.1.4.1.9.9.47.1.3.1.1.11 to ask the caller id works fine in the 5300, but returns all empty values in the 5400.if i run sh caller ip in the CLI of the 5400 or 5300 ...

Are there any MIB variable that can help me to collect unicast, broadcast, multicast traffic counters for ISL configured ports?In current MIB structure the unicast traffic counters are not populated properly in the interface part of the MIB. Actually...

Can I cascade together a 3508 switch with two 2948G-L3 Layer 3 switches with GigaStack cards?I think I remember hearing that you can't, for some reason, GigaStack layer 3 switches with layer 2 switches. True or not?

Where I can get basic info of how to config a PP T1 on a 2616 routers

hi could any one tell me, what all is to be considered before buying any router OR how does one selsect the router that is best suited for individual need.thanksAli

will the fast setup software work on a 2620. ios version 12.1? im trying to configure NM-8am on a 2620, using fast setup software, no success so far. 'appreciate any helpTIAomni-support