Hello,I need software for monitor traffic on my cisco 2500.I need to know how much traffic is used on my internet connection.thanks
Hello,I need software for monitor traffic on my cisco 2500.I need to know how much traffic is used on my internet connection.thanks
Does anyone know the SNMP OID for current Backplane Throughput on Catalyst 5500 and 6k switches.Thanks..
Hi,Can any suggest me a good Network monitoring tool (Windows Platform) which should support ping testing for multiple IP addresses with email handlers, alarms.Thanks in Advance.Ganesh.I
I am very much new and find this forum very useful. I would like to know if there is any GUI management software for Cisco 2900 switch.If there are any, where can i get them. quite urgent please!
how can i check how much bandwith is utilised in my atm links.
I have ran most of the show and debug commands and seems like everything is up and running (active), but I can't seem to be able to ping or telnet between the router and the switch. The only thing I can think of is that I configured the routing prot...
hi alli am have configured xyplex terminal server as access server to ciso router. its connects to routerbut problem is when i run commands like "sh int" or any commands which display more the 15 lines.its not dispalying after 15 line. i don't know p...
I'm looking for opinions on the necessary memory to run BGP4 for external routing and using CEF for a dual T-1 connection on a 3640 router. We have another route in running on a Cisco 7205 that we will also configure for BGP4, so we will end up with...
I am new to VPN design but now I have been charged with setting up a VPN for my organization that will allow remote users to access our network from there homes. We have a PIX 520 that I am in the middle of getting prices to upgrade for it's future u...
I have an MPLS-TE FRR question. I want to configure link protection for a specific tunnel. The FRR command and the backup tunnel are on the same router. I can see in the FRR database that T1000 the backup tunnel is for T0 but when I shut down the P...
we have mpls mesh , the PE is 7200,now i have 20 CE 2620s, 2 E1 from each 2620 connect to the 7200,the 2620 connect 8 VLAN, each vlan has a isolated bussiness, for exmple :2620 A VLAN -1 wants to make VPN to connect only 2620 B VLAN -1,so each vlan s...
i want use 2620 do MPLS PE router ,can it be feasible ,is it canwhich IOS should the 2620 support?andcan support how many vpn id?or how big vrf
In the Cisco 7513, command "show interface s0:0"I show the message,"15457 output buffers swapped out"what do them mean?
i have a 5505 at a remote site that seems to have a possible problem (though not affecting production). when i log into the 5505, via telnet, the password prompt comes up immediately... then, when i enter the password i don't get the next response fo...
When i monitor a port within Ciscoview i sometimes get ip errors.However when i do a sh int on the msfc card it all looks fine (no int errors)Maurice
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
02-20-2024 07:45 AM | ||
02-15-2024 09:08 AM | ||
02-14-2024 04:00 AM | ||
11-10-2023 09:28 AM | ||
11-09-2023 09:30 AM |