Other Network Architecture Subjects

I'm trying to find out if a Full T1 line should be or could be as fast or faster than a home dsl connection. The company I work for has a full T1 line. I was told by our provider that we are using very little of our T1 line's band width. When I conne...

Hi,We're facing problems while streaming intensive streams from our video streamer to the network.Is there any restrictions in terms of bursts, packets size, time between packets, etc ?Thanks.

We have a B class network all over the building (1200 hosts) and I'm planning to isolate the network via Layer 2 Vlans. we need 18 Vlan's. We have 6 2900XL switches connected to a 4006 switch via 6 fiber ports (WS-X4306). We have the Router module (W...

2950 switch stops responding when enter any command at CLI (show ver, config, ?)Any advices?

I have what I think are strange results via ping.From a machine I can ping a certain address.From the machines gateway router I cannot ping that same address. Any ideas or theories?????Thanks

I have defined a custome report in RME > Admin >syslog analysis>define custom report, but I am not sure where to look for the output of this report.Any help will be appreciated.

This is a general concept i want to understand.If i configre vlan 1 on 3524 with ip 10.10.10.1/8 and another 3524 with 10.10.10.2/8 on vlan 1.and conncet the switches through crosscable,sure im able to ping.Now if i leave the 1 switch with the same c...

I need to connect a cable modem to a Cisco 2600 series router. The Cisco router should allow network users to share the cable connection. One port will be direct connect to the modem, the other port of the router will be connected to hub, which then ...

Can you bond/aggregate ISDN lines. For example take 3 ISDN lines and get a complete 384K pipe. Can this be done with a Cisco 2600/3600 with a NM-4B-U or a NM-8B-U ?Thanks

I have what I think are strange results via ping.From a machine I can ping a certain address.From the machines gateway router I cannot ping that same address. Any ideas or theories?????Thanks

Hi, I have a star topology with a Catalyst 4006 and 5 Catalyst 3548. I cannot active the switchport in mode multi cause my catalyst work with VTP (trunking)What can i do to active multi vlan ?Thanks

I have a pair of two link FECs w/ISL configured from two different 6509s (Sup2/CAT6.1.1b) to the same 7513(12.0(19)). While both seem to be functioning, I am seeing a few disturbing issues. 1) Using an extended ping, I am dropping 6-9% of my packets...

I have a very simple question. When you do a "show int" command, are the indented values directly under the line that reads "Five minute output rate..." the values for the last five minutes, or a total since the counters were last cleared?I have hea...

I have configured the primary router,(2620)INDY, with an external ADRAN TSU LT. The second router, (1720)NASH, has an internal CSU/DSU. I have put an IP address on the serial interface and basicaly the routers are connected to each other with a cro...

I am not very knowledgeable about router configuration, so please bear with me. We have just implemented a 64/128 frame-relay to our branch office. We are running a client-server application that requires data compresson to be turned on.I've review...