Other Network Architecture Subjects

Can i do rate limiting for port 80 traffic on my 3550. If so can u please help me on the config. I want to rate limit on a single port

I need to do policy based routing based on the incoming IP address. All the addresses are coming in through a VPN concentrator and will be directed to one IP address on the concentrators policy, the concentrator will then pass the traffic to a switch...

I have a 3745 router recently returned from site. Upon boot, following error appears immediately: -"519: %PS-3-MULTFAIL: There is more than one failure with the Power System 2; please resolve problems immediately"Any help much appreciated!

Ok I have something wrong going on.I have 2 core layer 3 switches in HSRPVlan 10 172.18.10.0/24Vlan 20 172.18.20.0/24Core1 int vlan 10172.18.10.2standby ip 172.18.10.1int vlan 20172.18.20.2standby ip 172.18.20.1Core 2int vlan 10172.18.10.3standby 172...

If I have a (4) swtich stack, can I mix the images on the switches. ie: Can I have (2) 3750's running Enhanced and (2) running Standard? I'm guessing I can't, but would like to get confirmation one way or the other.Thanks

I have a Catalyst 4003 running CatOS version 4.5(2).When I type show module, I get that Switching Supervisor is faulty Switching Supervisor WS-X4012 faultyOther two modules are ok. Why?When I type show system I get the Sys-Status as f...

When connecting a printer to a jack that's patched to port fa0/10, I get nothing no link light. But When I connect a pc I get connectivity. Why no connection for the printer? I confirmed printer is good w/another port on the same switch and it works....

I am using a 6500 catalyst , when i shut down a (SVI)vlan the admin status is up and the line protocol becomes down, the status in the show vlan brief is admin/lshut i can reolve this only by doing a no vlan #i am not able to reproduce this but happe...

Hi allI am told in a named access list you can delete but not insert entries, is this correct ? Also I have seen different numbers on the list like50 permit x.x.x.x60 permit x.x.x.x70 permit x.x.x.x etcwhat are these numbers for ?cheers

whats kind of interfaces can frame relay be set up, does it use normal serial ? or can you use other kinds ?

What is the purpose of this area 0 ? why do we have to have it and what does at do ? also would you have a better router in this area ?

have have tried on 2 routers. 1803, and 2600 to use named access list, by typing access-list "extended" name, it will nto let me type this in, is there any reason why it wont let me do this ?

Hello,I recently got a cat 3524 but I cannot connect to it through the consle port.(settings and cables were double checked and they are all good).When I do a CDP from another Cisco device, I get the response from the switch saying thatIP is 0.0.0.0....